Monday, March 31, 2014

Started Mounting Electronics to New Electronics Board

Tonight I started the task of mounting the electronics on the new electronics board for droid #2.

I spent quite a bit of time loosely laying out various configurations, before settling on a placement that I hope will work well.



Time to start drilling. I used various parts as templates for where to drill.

The attachment for the speed controller.



The large hole for connectors to pass through.



Using the dome controller mount plate as a template.



Finally, I used the mounting holes on the Stealth hardware as a guide to mark where to drill, and then drilled the three holes for the DC converter, and the four holes for the Stealth Receiver.



For the Stealth hardware, I'm using #4 screws from underneath, and nylon standoffs and nuts, in order to avoid having metal contact metal. Also, I chose longer screws in case I decide to cover these electronics with plexiglass.



The electronics board, as it currently stands. Loose wires will be cut to size and soldered and/or attached to their mount points, which should help clear up the clutter.



And the electronics board, as I hope to have it in the next day or two.


3 comments:

perello23 said...
This comment has been removed by the author.
perello23 said...

Looking good! :)

Victor Franco said...

Thanks Ed!