Wednesday, December 13, 2006

Battery Harness Pins

Back from another business trip, I was able to get a minimal amount of work done tonight.

I drilled the resin battery harness pieces to accommodate a 1/8" pin that goes through the hinge area.

I also cut a 1/8" diameter metal rod (the same rod used as pivots for the utility arms) to form the pins of the correct length. I tried each of them out for size as they were cut.

I also filled pinholes in the top of the center foot shell, I'll give that a final sanding tomorrow. I can only get piddly stuff like this done on weeknights these days.

No comments: