I printed several of them on one transparency, because, why not? And I cut two of them out because I will be doubling up on them to make the colors look a bit deeper when the LEDs are shining through them.
I vow to get these installed tomorrow.
Thursday, June 15, 2023
Printed Transparencies for Rear Logics for Droid #2
I had higher hopes for today, but all I ended up doing was printing and trimming the LED pattern for the rear logics, for the PIC flasher-based rear logics on droid #2.
I printed several of them on one transparency, because, why not? And I cut two of them out because I will be doubling up on them to make the colors look a bit deeper when the LEDs are shining through them.
I vow to get these installed tomorrow.
I printed several of them on one transparency, because, why not? And I cut two of them out because I will be doubling up on them to make the colors look a bit deeper when the LEDs are shining through them.
I vow to get these installed tomorrow.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment