Center Foot Trim, Another Round of Evercoat for Second Outer Foot Shell

During Saturday's work on the center foot, the strips I glued on top of the channel area were cut just slightly too long, on purpose.



A couple of minutes with a file and sand paper made short work of that.



Next, I still needed to deal with a few minor uneven areas on the second outer foot shell. First, I sanded the primer in the areas that needed work.



Then, on went a thin layer of Evercoat.



After the Evercoat had dried, I sanded it smooth.



I sure hope that is the last time I need to do that, but I will spray some primer on it tomorrow and see.