Reattached Front Vent Panel

Going in circles, I yet again attached the skin panel that goes around the front vents. My earlier attempts at this using silicone and 3M VHB tape were unsuccessful, because the panel had been bent slightly to remove some of its curvature. I rebent the panel slightly to the correct profile.

I decided to go with the 3M VHB tape, rather than mess around with silicone this time.



The corners seem to be holding well. Time will tell, but I think this just may work out.



I have an event coming up next Sunday. Depending on how lazy I am, I may or may not have much to report between now and then, we'll see.