Shoulder Hub Template Prep, JB Welded Servo Rods in Utility Arms

In the morning I did a little work in preparing my shoulder hub template for cutting tomorrow. This is mainly an experimental template, I don't fully expect that the hubs will fit perfectly on the first try. We'll see.

In the evening I trimmed the rods that will go in the ends of the utility arms for the servos that will open the arms, and JB Welded the rods into place.

The JB Weld that looks like it dripped in other areas is actually left over from when I was filling in small gaps and voids in the resin, when I JB Welded in the pivot rods.