Today I worked on the PVC housings that will host the dome electronics on Mike's droid #2.
Most of the time was spent measuring, marking and cutting the assembly for the front logics. I recycled an old piece of PVC for the base plate, and then marked where to cut the piece that will hold the logic boards.
Time to bring the Dremel out of retirement and get some cutting done.
I cut a few vertical strips that are used to mount the assembly at the proper angle. Everything is loose-fit for now, but I plan to start gluing it up soon.
I also cut a couple of base plates for the front and rear PSIs. I still need to cut the vertical supports for each.
Tuesday, December 27, 2011
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment