Wednesday, September 16, 2009

JB Welded Pivot Rods in Utility Arms

Tonight I JB Welded the pivot rods into the utility arms.

I whipped up a batch of JB Weld, and used a toothpick to apply it on the inside of the pivot holes in the arms.



Next, the segment of rod goes in.



Finally, I lined everything up so the arms are perfectly centered vertically in the skins.



I used some quarters to make sure the arms don't sag as this all dries overnight. Won't it be amusing if I JB Welded a couple of those quarters to the arms? (I think not.)



Hopefully tomorrow I can finish up the arm mounting, we shall see.

No comments: