Saturday, July 16, 2005

Cut Horizontal Rib Rings, Pie Wedges & Marked Up Joints

I cut the 1"-wide rings for the horizontal ribs by cutting a normal circle like those that form the top and bottom bases, and then cut an inner circle using a jig saw. Two of these were cut to supply all the horizontal ribs. Also cut the pie wedges that will support the shoulder planks that I cut yesterday. Most of the tip of the pie wedges will be cut to fit against the planks.

Also marked up where the dado cuts will go for both the horizontal and vertical ribs:



Getting close!

3 comments:

Unknown said...

peut on avoir les dimensions de chaque pieces s'il vous plait

Unknown said...


we may have the dimensions of each parts please

Victor Franco said...

Blueprints and measurements are at http://www.astromech.net